ramrod
New member
It's 11 pm right now and I finished installing my Driven CR Low Oversized (1-1/8'') handle bars and Driven D3 Aluminum grips. I have a set of Driven bar ends but waiting for the adapters since they are on back order.
The installation was fairly simple, in fact I took enough pictures to make a brief write-up if the anyone wants. The bars, clamps and bar ends are top notch and highly recommended. The grips are not quite what I expected... thought they'd be more like rizomo's I had on my 919.
I ended up trimming 3/4'' on either side to shorten the bar in a little and I have it adjusted at about a 2 according to the printed gauge. I only took it for a quick spin around the block and so far so good. I will write about the installation here perhaps tomorrow, need to get in a couple hours before work.
Enjoy the pics:
The installation was fairly simple, in fact I took enough pictures to make a brief write-up if the anyone wants. The bars, clamps and bar ends are top notch and highly recommended. The grips are not quite what I expected... thought they'd be more like rizomo's I had on my 919.
I ended up trimming 3/4'' on either side to shorten the bar in a little and I have it adjusted at about a 2 according to the printed gauge. I only took it for a quick spin around the block and so far so good. I will write about the installation here perhaps tomorrow, need to get in a couple hours before work.
Enjoy the pics:
Last edited: