Led turn signal front bracket

[BigD]

Anyone close up pics of how they fit the front flashers as the oem is held on by a large rubber bracket yet once all removed and the new led flashers had a small bolt and small rubber..how is best to hold this in place?
I have the blanking plates to fill the gap (which is too big and has to be filed down anyway) still...how is best to hold it all in place? Use the old rubber bracket?

Cheers


Sent from my iPhone using Tapatalk

 

[HeresMyMind]

I used the old rubber parts, it allowed them to stick out a bit farther, its not the prettiest but it helps them be seen

-B

 

[BigD]

I used the old rubber parts, it allowed them to stick out a bit farther, its not the prettiest but it helps them be seen

-B

Don't suppose you know of any pics showing use without rubber parts?


Sent from my iPhone using Tapatalk

 

[HeresMyMind]

Here is a picture less than 2 minutes old.


like i said, not the prettiest, but the most effective IMO.

-B

 

[BigD]

Here is a picture less than 2 minutes old.





like i said, not the prettiest, but the most effective IMO.



-B

Yeah I see.
Here is mine...sticks out a bit further but wish I could flush fit it tbh...

Sent from my iPhone using Tapatalk

 

[HeresMyMind]

Black Carbon Stalk Turn Signal Adapter Plate Yamaha YZF R6 R6S 03 10 11 12 13 14 | eBay

you put one on the inside of the plastic, 1 on the outside, then bolt down, it sandwhichs in around the oem opening

-B

 

[BigD]

Aha ok. Makes sense cheers


Sent from my iPhone using Tapatalk

 

[cla4de]

or use black washers works great