Well I installed my motodynamic tail light today and while I was at it I fabbed up a fender eliminator using the metal "spine" from my factory snow shovel fender. I still have to get a pair of the LED license plate bolts and wire up so I have a light for the plate. I don't have a bunch of extra cash and I prefer to make my own stuff anyway (getting it from being a jeeper) so I wasn't going to pay for a FE. I was gonna go the route that a lot of people went and get some thin sheet metal and bend it, paint it and bolt it up. Then I got to looking at the metal frame inside the factory fender and saw that the factory plate holder was a little piece of metal that was bolted in place and got to thinking. I cut off all but a small tab of metal from the frame, bent the ends in, marked it for the plate holder, drilled the holes, painted it and bolted it all up.
Here's the pics I took. In the pics I still hadn't painted the brackets so just ignore that. They're a nice flat black now. I could have made the bends a little prettier if I used my friends bench vise and I could have cut the points off the tabs but it's all covered and I was kind of rushing it. You can see it anyway once the tag is on so who cares?
Here's the piece I cut off the frame and bent in.
Here they are mounted up.
Here's the tag holder mounted up to the brackets.
And all finished up!
So what do ya'll think? Opinions? Anything I missed? Oh and I LOVE the look of the tail end now!! Oh and don't mind my messy porch. I don't have a garage so this is where the bikes stay and get worked on. LOL It's fully enclosed so it's as good as a garage I guess.
Here's the pics I took. In the pics I still hadn't painted the brackets so just ignore that. They're a nice flat black now. I could have made the bends a little prettier if I used my friends bench vise and I could have cut the points off the tabs but it's all covered and I was kind of rushing it. You can see it anyway once the tag is on so who cares?
Here's the piece I cut off the frame and bent in.
Here they are mounted up.
Here's the tag holder mounted up to the brackets.
And all finished up!
So what do ya'll think? Opinions? Anything I missed? Oh and I LOVE the look of the tail end now!! Oh and don't mind my messy porch. I don't have a garage so this is where the bikes stay and get worked on. LOL It's fully enclosed so it's as good as a garage I guess.
Last edited: