BanditGville
New member
Hey everyone here is a how to for anyone wanting to do this who is hesitant because they do not want to mess anything up.
It is very simple and now its even more simple. Enjoy.
Locate throttle, remove bar end.
Slide the rubber boot off the end.
Use a 4mm Allen loosen two mounting screws.
Both screws loosen
Remove Upper cover
Remove Lower cover
Remove Top cable
Remove lower cable
Slide off old and on NEW
Now spin the throttle upside down and install the lower cable first.
Rotate throttle FORWARD
Attach upper cable
This washer (Comes installed) Goes to the OUTSIDE of the housing. It WILL bind up and not work.
Lower cover installed hold it up with hand as shown
Upper cover installed
It is very simple and now its even more simple. Enjoy.
Locate throttle, remove bar end.
Slide the rubber boot off the end.
Use a 4mm Allen loosen two mounting screws.
Both screws loosen
Remove Upper cover
Remove Lower cover
Remove Top cable
Remove lower cable
Slide off old and on NEW
Now spin the throttle upside down and install the lower cable first.
Rotate throttle FORWARD
Attach upper cable
This washer (Comes installed) Goes to the OUTSIDE of the housing. It WILL bind up and not work.
Lower cover installed hold it up with hand as shown
Upper cover installed
Last edited: