Front Turn Signal replacement

[adams614]

Finishing up this falls MODs to the bike and would like to replace the stock front blinkers with flush mounts or LED's.

I've seen a few posts about getting to the wiring but wanted to see if any one had a bit more detail to add.

I've read that you need to remove some screws to get at everything. Or those around the headlight and dash?

I'm thinking its pretty straight forward but don't want to remove anything that isn't needed to get them swapped out.

Thanks for any Insight.

Jeff.

 

[thach1130]

Take out two screws holding the tiny windscreen in front of your dash. There are 2 screw underneath you need to remove. There is 1 screw on the bottom of the headlight near the fork you need to remove. The whole headlight should be able to be detach enough for you to reach behind and unplug the headlight plug. There you have it, the whole headlight assembly should be in your hand. If you need to access the inside to change the turn signal there are two screws holding the sideburns of the headlight.