Recent content by rocketz

d:60 is EEPROM fault code display, 00 mean no fault code history from your bike.so no way you can adjust unless you reset to 0 d:70 is control number

and the symphtom come again....bike wont start,crankin but no ignition .the difference is now sometime no fault code and no imobilizer light up..sometime fault code 12,41,48...:eek: i better think to put this bike on the museum.

hereward,i think we have the same case http://www.779cc.org/forum/fz8-technical/3014-crankin-ignition.html

in my country,i imported the bike by myself.so no warranty neither insurance.

after i charge battery to full,i found more fault code on dash.12(crank) 41(lean angle sensor) 48(athmospheric pressure sensor) these drive me crazy. i try to browse, and i found this code 12 WAS NOT generate because of only sensor,wiring harness,ECU connector.This Yamaha bike was programmed to...

ok,this is what i am doing now. 1.I do connection test from crankshaft position sensor to coupler both side ...no problem. 2.I test resistance of crankshaft position sensor(service manual reference)..no problem 3.according to wiring diagram GREY cable lead to directly to ECU.i test from...

as i wrote before,in my country there is no yamaha big bike workshop.if i have them here i wont write here.

i called this bike "stupid and miserable bike" ok,i am truely angry by now.my bike was not move from 1 yrs ago and i try myself asking and searching everywhere.any mechanic and read everywhere.this guide me to lost,pls read above. 1.Bike crankin sometime but cant ignite.mostly cant be start...

is this relevant? My 2008 R6 showing HI temp on display : Yamaha R6 : R6 Forum

no bro,this bike completely stock.only horn and hid light i have change..

Until now,my bike still on the stand.i have try to replace immobilizer reader and thermostat sensor to brand new one.nothing change. Now,before i replace ECU,imobilizer reader unit,key,and fuel cap.i have to deep checked that these things are broken.first now i test wiring harness and found...

i thought it was only a code reader.what do you think about HI indicator? do you have same condition? thanks

is it possible thermo sensor failure cause Hi and ecu prevent from start up?

does anyone here know yamaha mechanic email adress or contact info? regarding to my problem.where should i contact...pls help

i want to,but as you can see on www.yamaha-motor.eu,i cant find any email or phone number.while on usa,this bike is european.