Recent content by RD GUY

anyone know torque specs front and rear spockets?

you might want to rethink your 50/50 mix as engine ice is not to be mixed with other types of antifreeze or water,

just did the plugs,walk in the park,took me less than a hour,after undoing the rad i only had to cut the tyewrap holding the fan wire and it gave me lots of room

the lock is off a wr250x and I fab the plate to mount it to

I got mine from my Yamaha dealer two day 525pitch vortex rear 48 #641CZK-48 afam front #21607-15 got when i changed tires just incase,but after 13000kms they were still like new

heres how I lock my helmet

I had no problem finding them ,been running them since I got the bike call tony at 519-475-9055 at blue streak racing and give him the part numbers and see how fast he can get them

I just got a front from my local Yamaha dealer in 3 days afam 15 tooth part#21607-15 and vortex rear 48 tooth part#641C-48 in black just to have in my own stock for when I need to replace the ones I already have on the bike,give tony a call at bluestreak racing in Canada .I think he has free...

first off I am no expert,been to the track on the 8 a few times,the key to getting a good time on these bikes is in the launch,so heres how I do , I don't do a burnout just roll up to the tree rev to 8000rpm then dump the clutch at the last yellow light, and pin it than shift at 11000rpm...

in stock trim the fz8 runs low 11's also your reaction time does not affect your et time.

heres a better pic

got the Yamaha oem came all white so I got a little creative .

K/N filter,YOSH R77 slipon,-1/+2 gearing that's it .

i went -1/+2 and installed the speedohealer, it took 15 minutes to install and my speedo was out by 20kilometers

I have gone to the track a few times the best way I launch is at 8000rpm I usually run low 11,s but i did do a 10.9 pass once .