Ok. I emailed you and I just got the bulb to fit. But I emailed you about all the order info. Thank you
Got my H4 pigtail today and finished installig the headlight. Love it all. The light bounces a little more than i would like. Is that an install problem or the more intense light with me being able to see it?
did you tighten the back nut that holds the projector?
if the projector is tightly installed, then what you are seeing is the actual bike bouncing and thus the light is also bouncing.
with a stock headlight there is no cut off line, so you dont see the light move around as you ride.
with a projector you have a very sharp cut off line, so you will see the light bounce around the same as your bike is bouncing around, so its not that the light is not secure, its just your bike bouncing and now you can actually see it.
Not sure what I did wrong, but my low beam/high beam controls my halo??? Please help and also did you use anything to fix the halo onto the projector, looks like mine is going to fall off if if I hit a bump, it's not really holding solid on the projector.
Mine was the same like yours. Don't worry, everything it's ok... Just change the cables from the socket. That pic from the installation progress is incorrrect... You have to change the blue/white/black until everything works ok. Im not a electrician, but is a try/fail job. Be patient... And for the halo, mine came solid, i'ld recommend you some silicone if you think is to loose. Hope it helps
Thanks I'll try to figure it out, so your halo was turning off with the high beam switch too?
I used a thin bead of contact cement . I put mine out by just clipping it in and it did fall off after a few days. I had to take it all apart and open the casing back up. Annoying as hell
Sent from my SGH-I527M using Tapatalk
Yeah it has held in place nicely . Its only been two months but no movement as of yet !
Sent from my SGH-I527M using Tapatalk